Hot Dipped Galvanized Mild Steel Cold Bending Wide ss304 cable trunking

 Cable Tray»            Strut Channel»         Pipe Clamp»        Solar Mounting»       Threaded Rod»           Bracket»          Description of Cold Bending Wide ss304 cable trunking

Material	Carbon steel or SS304 or SS316( Q235B Steel,Chinese standard steel)
Surface Treatment	HDG(hot dipped galvanized ),Pre-galvanized,Electrical-galvanizing(yellow or white),powder coating(Black,Green,White,Grey,Blue)etc.
Dimensions	13/16"x 1-5/8" or 1-5/8" x 1-5/8",1-1/2"x1-1/2",3/4"x1-1/2"
Lengths	Either 10FT or 20FT or cut into the length according to clients' requirements
Size	50mm*25mm or 100mm*50mm or 500*200mm, 800*200mm,and so on
Thickness	1.2mm, 1.5mm,2mm,2.5mm, 3mm
MOQ	1000 Pieces
Packaging	In Bundles and fasten with steel strips or by wooden pallets
Application	Intelligent room
	IDC equipment room
	Cloud computing equipment room

Picture of Cold Bending Wide ss304 cable trunking Parameteres of Cold Bending Wide ss304 cable trunking

Size(mm)	Thickness(mm)	Thickness(mm)
50×25	1.2	1.5
75×50	1.2	1.5
100×50	1.2	1.5
100×75	1.2	1.5
100×100	1.2	1.5
150×50	1.2	1.5
150×75	1.2	1.5
150×100	1.2	1.5
200×100	1.5	2
250×100	1.5	2
300×100	1.5	2
300×150	1.5	2
400×100	1.5	2
400×150	1.5	2
500×100	1.5	2
500×150	1.5	2
600*100	2	2.5
600×150	2	2.5
600×200	2	2.5
700×100	2	2.5
700×150	2	2.5
800×100	2	2.5
800×200	2.5	3
1000×200	2.5	3
1000×250	2.5	3

Model and Design of Cold Bending Wide ss304 cable trunking  1. Elect the environment conditions. Usually there are three kinds of environment conditions; one is corroding environment, such as alkaline—chlorine factories, another is usual environment, that is regular environment, such as air corrosion the third is special environment, such as exhibition rooms. 2. Elect the run. According to the general plane arrangement figure and the concrete conditioner of technological pipe wire, water pipe and vapor pipe wire, you can elect the nearest run Of cable ducts, not laying on the wall, beam post and stairs indoors, laying on one—side of techonolislcal pipe frames as possible outdoors, if there are no pipe frames, you can only set up posts. 3. Lead calculation. Geocal=n1q1+n2q2+nnqn······, in the formula, q1q2q3······ is the weight of unit length cable respectively, n1n2n3······is the correspondent pieces of cable. G should be smaller than the pertled load of cable duct (referring the load curve Chart) when cable ducts are is the outdoor or has the protective cover, such elements as water load should be considered. 4. Select bridge: Decide the type and specification, the space of the column, the length Of the support, the gradation of the bridge the length Of the column and etc according to the surroundings of the load of the cable and installation place the bridge and use load curve of the bridge as the base. 5. Decide the fixing method: suspension type, vertical type (these two types both may adopt single side fixing method or double—side fixing method) , wall—side type and etc Of the bridge according to the trend of the cable and the surroundings of the installation.  The advantages of Cold Bending Wide ss304 cable trunking: 1. Low cost, significant cost savings compared to standard traditional tray products. 2. Light in weight, wide range of sizes. 3. Fast heat dispersion. 4. Strong enough to withstand short circuits. Provides strength, rigidity without additional hardware. 5. Adapts to difficult architectural designs to accommodate changes in direction and elevation of cable runs. 6.Flexible, easy and fast installation. Design allows cable exit or entry at any point. 7. Cables can be secured to clamps or ties. 8.Various hardware accessories available to fix, support and install. 9. Safe smooth edge design to protect cable. 10.Easy for line check and cleaning , easy maintained. 11.All sharp ends are cut off to protect cables. Weight loading capacity is 27% stronger than traditional cable trays and cable ladders.  Features: -- Cable Trunking are easy to install and can be mounted on walls using brackets. -- Used for underfloor, concealed systems. -- Cable trunking with cover sections to prevent ingress of dust and liquids. -- cable ladder permits the maximum free flow of air and allows the heat effectively dissipate. -- the rungs of the cable ladder provide convenient anchors for tying down the cables in different way. -- cables can be easy to exit or enter through top or bottom of cable ladder. -- moisture can’t accumulate in cable ladder.  Ventilated cable tray: offers good ventilation to the cable which will accordingly increase the current carrying capacity of the cables.  

Contact us if you need more details on Ss304 Cable Trunking. We are ready to answer your questions on packaging, logistics, certification or any Other aspects about Wide Cable Trunking、Stainless Steel Cable Trunking. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Cable Support Systems > Steel Cable Trunking